We'll need some more details to help debug (what was your configure command,
what compilers are you using, how did you install/set up those compilers,
etc.). I use Macs extensively and I've never seen this issue. Perhaps
you're trying to use the GCC version 4.6? If that's the case, try
installing an older version from MacPorts and use that.
HTH,
Jason
On Wed, Jul 6, 2011 at 6:08 AM, Jennifer L. Muzyka <
jennifer.muzyka.centre.edu> wrote:
> We're trying to install AmberTools 1.5 on a Mac running OSX 10.5. When we
> get enter "make install", we get the following error:
> ../../src/eigen3b2/Eigen/src/Core/arch/AltiVec/Complex.h:137:30: error:
> 'sum' was not declared in this scope
> make[3]: *** [sheet.lo] Error 1
> make[2]: *** [install-recursive] Error 1
> make[1]: *** [install-recursive] Error 1
> make: *** [install_mtkpp] Error 2
>
> We'd appreciate advice about what these errors mean and so that we can
> proceed with installing Amber 11. Thanks.
> Jennifer
>
>
>
>
> Jennifer L. Muzyka
> Professor of Chemistry
> Centre College
> 600 West Walnut Street
> Danville, KY 40422
>
> jennifer.muzyka.centre.edu<mailto:jennifer.muzyka.centre.edu>
> http://web.centre.edu/muzyka/
>
>
>
>
> _______________________________________________
> AMBER mailing list
> AMBER.ambermd.org
> http://lists.ambermd.org/mailman/listinfo/amber
>
--
Jason M. Swails
Quantum Theory Project,
University of Florida
Ph.D. Candidate
352-392-4032
_______________________________________________
AMBER mailing list
AMBER.ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber
Received on Sat Jul 09 2011 - 08:30:03 PDT
