Hi,
Just put a .pev extension on the eigenvector file you obtained from nmode and you can read this into IED. You load a pdb and then this .pev file.
Have a look at this communication on amber archive:
http://archive.ambermd.org/
Regards,
Nadia
________________________________________
From: owner-amber.scripps.edu [owner-amber.scripps.edu] On Behalf Of Joachim Reichelt [Joachim.Reichelt.helmholtz-hzi.de]
Sent: 30 June 2008 13:36
To: amber.scripps.edu
Subject: Re: AMBER: nmode analysis
As far as I can see IED uses the output from ptraj/rdparm
Both are not reading the vecs file nmode writes out.
So you have to run e.g. sander to get a tarjectory.
So what are these vecs good for?
Mark Williamson schrieb:
> Joachim Reichelt wrote:
>
>> So what program can be used to visualize the modes. VMD does not uses
>> them but the tarjectories.
>
> You might want to try Interactive Essential Dynamics, since IIRC this
> can do what you want:
>
> http://mccammon.ucsd.edu/ied/
>
> http://dx.doi.org/10.1007/s10822-004-4121-z
>
>
> regards,
>
> Mark
> -----------------------------------------------------------------------
> The AMBER Mail Reflector
> To post, send mail to amber.scripps.edu
> To unsubscribe, send "unsubscribe amber" (in the *body* of the email)
> to majordomo.scripps.edu
--
Joachim
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" (in the *body* of the email)
to majordomo.scripps.edu
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" (in the *body* of the email)
to majordomo.scripps.edu
Received on Wed Jul 02 2008 - 06:07:20 PDT
