Dear Amber community,
Our installation of Amber8 was set up to work with Mpich2 via:
>./configure -mpich
with MPICH_HOME pointing to the Mpich2 directory. Subsequently the
"make parallel" step was undertaken and all went smoothly. However,
upon attempting to run sander the following error is reported:
>huey# sander -O -i min2.in -o min2.out -p \
>2c9_114mutantCminfix1solvateions_flp.top -c \
>2c9_114mutantCminfix1solvateions_flp.crd -r \
>2c9_114mutantCminfix1solvateions_flp.rst &
>[1] 633
>huey# mpd_singinit: execv failed: No such file or directory
My best guess is that with Mpich2 the "mpd_singinit" command is named
as something else. Any and all help would be greatly appreciated, as
always! - Msgr.E.J.Nolan IV
__________________________________
Do you Yahoo!?
Yahoo! Small Business - Try our new resources site!
http://smallbusiness.yahoo.com/resources/
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
Received on Thu Apr 14 2005 - 21:53:00 PDT
