('binary' encoding is not supported, stored as-is)
Actually it is moilview10.tgz from the Amber7 installation CD.
Are there any changes I need to make to these steps because of this?
==============Original message text===============
On Fri, 13 Aug 2004 16:41:27 EDT Viktor Hornak wrote:
I assume you got moilview10.2 from amber8 installation CD. Untar the
file "mview102.tgz" and 'cd' to 'source' in a directory 'moilview.10.2'.
Look at the 'Makefile' there and adjust if necessary. It should work
without any changes on most relatively recent SGIs (Octanes, O2s, etc.).
Then just type make and find the executable in ../exe directory.
-Viktor
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
Received on Mon Aug 16 2004 - 09:53:00 PDT
