Re: [AMBER] 'Process abort signal' when running sander or pmemd.

From: David A Case via AMBER <amber.ambermd.org>
Date: Wed, 12 Mar 2025 11:35:13 -0600

On Sun, Mar 09, 2025, ning via AMBER wrote:
>
>Sorry to have this question to bother you. Recently, I tried to install the
>Amber24 and AmberTool24 at both. When I finished the installation of serial
>version, I tried to run the pmemd command, but it complained as this below:
>
>
>Program received signal SIGABRT: Process abort signal.
>

This message per se doesn't provide any information, and we don't know what
sort of simulation you were running.

Have you run the test cases with your installation? That's a first step in
figuring out if the problem is generic to the installation, or is specific
to your particular input files.

....regards...dac

_______________________________________________
AMBER mailing list
AMBER.ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber
Received on Wed Mar 12 2025 - 11:00:03 PDT
Custom Search