Ya
Prof case is right about that.
Better run a smaller simulation specifying the cycles.
Better use ntmin=2, for your simulation. If it doesn't fix the
problem. do a smaller simulation.
On 8/13/09, case <case.biomaps.rutgers.edu> wrote:
> On Thu, Aug 13, 2009, s. Bill wrote:
>
>> I was trying to do simulation of a solvated protein using QM/MM
>> DivCon.
>
> Just a question: are you sure you want to do this? It looks like your
> quantum region is only 11 atoms. There is no advantage to using divcon, and
> you should remember that it has been tested by fewer people than the
> non-divcon
> QM/MM code. Plus, options like qm_pme and qm_ewald are ignored by divcon,
> which may not be what you want.
>
>> atoms, and after 3ps it stopped, becuase a part of the protein moving
>> away.
>
> You probably need to run a simulation slightly shorter than the one that
> crashes, then look at the output coordinates visually, and start to figure
> out
> what is happening.
>
> ...dac
>
>
> _______________________________________________
> AMBER mailing list
> AMBER.ambermd.org
> http://lists.ambermd.org/mailman/listinfo/amber
>
--
Ashish Runthala,
Faculty Division III,
Assistant Lecturer, Biological Sciences,
Birla Institute of Technology and Science,
Pilani, Rajasthan- 333031
INDIA
_______________________________________________
AMBER mailing list
AMBER.ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber
Received on Wed Aug 19 2009 - 22:35:58 PDT
