Sorry, I meant if there's a sander input switch similar to NTWX, that sets a start time step for sander to output coordinates into mdcrd?
Dong Xu
UC, San Diego
________________________________
From: Carlos Simmerling <carlos.simmerling.gmail.com>
To: AMBER Mailing List <amber.ambermd.org>
Sent: Tuesday, April 21, 2009 4:26:02 PM
Subject: Re: [AMBER] Set start timestep for mdcrd traj output
trajectory frames don't have time step information.
ptraj can check the # of frames.
On Tue, Apr 21, 2009 at 12:38 PM, quantum_mania.yahoo.com
<quantum_mania.yahoo.com> wrote:
>
>
> Hi,
>
> Is it possible to set a start timestep (instead of at the very beginning of MD run) to output the coordinates in mdcrd file?
>
> Also, what's the best way to check the number of frames in a mdcrd traj?
>
> How to make sander to write binpos format traj file?
>
> Thanks!
> _______________________________________________
> AMBER mailing list
> AMBER.ambermd.org
> http://lists.ambermd.org/mailman/listinfo/amber
>
_______________________________________________
AMBER mailing list
AMBER.ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber
_______________________________________________
AMBER mailing list
AMBER.ambermd.org
http://lists.ambermd.org/mailman/listinfo/amber
Received on Wed May 20 2009 - 12:10:41 PDT
