Dear Dr. Case,
Thanks for your response. I do not know why either. But this is not what
I most concerned. I am expecting to know why nscm should be set to 0
when ntt=3.
Thanks,
Shaowen
-----Original Message-----
From: owner-amber.scripps.edu [mailto:owner-amber.scripps.edu] On Behalf
Of David A. Case
Sent: Friday, April 13, 2007 2:48 PM
To: amber.scripps.edu
Subject: Re: AMBER: nscm in simulation annealing
On Fri, Apr 13, 2007, Hu, Shaowen (JSC-SK)[USRA] wrote:
>
> There is "RE_POSITION Moving by" messages every nscm step in my
output.
This indicates the the coordinates are changed, but the velocities are
not changed. It is still not clear why (or even if) you are seeing
differences in the temperature control depending on what value of nscm
you use.
....dac
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
Received on Sun Apr 15 2007 - 06:07:45 PDT
