Dear Annie,
> I tried to run the xleap, however, the following error
> message appeared.
> What can I do to solve it?
>
> [tutorial]$ $AMBERHOME/exe/xleap -s -f
> $AMBERHOME/dat/leap/cmd/leaprc.ff99
> AMBERHOME/exe/xaLeap: Command not found.
>
> I can see xleap and tleap in the AMBERHOME/exe directory, but
> I cannot see
> teh xaleap one.
I suspect that your xleap build did not complete correctly. Go back to the
compilation phase and take a look at the last few lines of the output as
amber compiles. Xleap is the last thing that gets build and so any errors
you see here will be failures in the xleap build. I suspect the problem is
that you likely don't have the X11/xorg development libraries installed on
your system. Typically Linux installations where people just choose the
typical option does not install any of the development libraries which can
make compiling a lot of programs a real pain. Check that you have the X
development libraries installed. If you do and you are still having problems
getting xleap to compile please send me a copy of any error messages you
see.
All the best
Ross
/\
\/
|\oss Walker
| HPC Consultant and Staff Scientist |
| San Diego Supercomputer Center |
| Tel: +1 858 822 0854 | EMail:- ross.rosswalker.co.uk |
|
http://www.rosswalker.co.uk | PGP Key available on request |
Note: Electronic Mail is not secure, has no guarantee of delivery, may not
be read every day, and should not be used for urgent or sensitive issues.
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
Received on Sun May 21 2006 - 06:07:06 PDT
