En/na Fabien Cailliez ha escrit:
> Dear all,
>
> I have a question about linit variable in mm-pbsa module for PBSA
> calculations.
> How do I have to set this variable ?
I have been running PBSA calcs for a 25 residues helix in an hydrophobic
environment, and tested linit=500, 1000, 5000 and
results seemed to have converged at linit=500 (i.e. no variation in two
significant figures between the respective output files)
Does it sound reasonable? Many thanks for your contibutions,
Arantxa
> Is there any message in the output which indicates that there is a
> problem with the
> number of iterations being too small ?
> I guess I have only to check if the line "Iterations required
> :" indicates less
> than linit, but I am not sure....
>
> Thanks for your answers,
> Fabien
>
Arantxa Sanz, PhD
Laboratori de Medicina Computacional
Facultat de Medicina
Universitat Autònoma de Barcelona
08193 Bellaterra
Catalonia, SPAIN
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
Received on Fri Apr 08 2005 - 10:53:02 PDT
