Dear Carlos,
Thanks for your suggestions- it finally worked. After minimization, I
used ambpdb to generate my pdb files-and the measured torsion angles
were the same. Heres my 2 input files ( min.in and rst.f).
Now I am looking for a dihedral angle driver for amber8. Any
suggestions..
regards, vincent.
min.in
....
minimization
&cntrl
imin=1, maxcyc=5000, ncyc=5000, ntmin=1,
drms=0.001, dielc=1,
ntx = 1, dt=0.002, nmropt=1,
ntb=0, cut=10.0, temp0= 200, tempI=200,
/
&wt type='END' /
LISTOUT=POUT
DISANG=rst.f
...........
rst.f
......
&rst iat= 5,7,9,32, r1=-210, r2=-180, r3=-180,
r4=-150, rk2=50, rk3=50, /
&rst iat=7,9,32,34, r1=-210, r2=-180, r3=-180,
r4=-150, rk2=50, rk3=50, /
&rst iat=0
/
Dr K Bisetty
Senior Lecturer
Department of Chemistry
Steve Biko Campus
Durban Institute of Technology
P O BOX 1334
Durban
4000
Tel : +27-031-2042311
Fax : +27-031-2022671
"ND-4-SPD"
bisettyk.dit.ac.za
------------------------------------------------------------------------------
Are you happy with the service you receive from my office?
If so - send a compliment; if not send a complaint to: quality.dit.ac.za
Please read our disclaimer
http://www.dit.ac.za/disclaimer/emaildisclaimer.htm
------------------------------------------------------------------------------
<<<<GWAVAsig>>>>
-----------------------------------------------------------------------
The AMBER Mail Reflector
To post, send mail to amber.scripps.edu
To unsubscribe, send "unsubscribe amber" to majordomo.scripps.edu
Received on Tue Oct 12 2004 - 08:53:01 PDT
