Dear all,
I try to use interface to run "torsion driving" (to generate an energy versus
torsion profile). I called interface in the following way,
/kvant/wangyn/amber/AMBER/exe> interface -i torsion_drive -t amber.dat
where torsion_drive is a test command file copied from the manual.
However, I got ERRORS like
sh: /usr3/people/builder/AMBER501/AMBER/exe/sander: not found
/usr3/people/builder/AMBER501/AMBER/interface/exe/direct: Command not found.
Starting set # 1
/usr3/people/builder/AMBER501/AMBER/interface/exe/archivgetd: Command not found.
sh: /usr3/people/builder/AMBER501/AMBER/exe/sander: not found
/usr3/people/builder/AMBER501/AMBER/interface/exe/archivputd: Command not found.
minxx_vac.out: No such file or directory
minxx_vac.out: No such file or directory
rm: minxx_vac.out: No such file or directory
rm: minxx_vac.rst: No such file or directory
rm: md1.xyz: No such file or directory
It is obvious that the directory (or architecture) is wrong, since all the
above executable programs are stored under
/kvant/wangyn/amber/AMBER/exe/ directory.
What should I do then? Many thanks for any suggestion.
Yanni
Received on Fri Sep 29 2000 - 08:42:48 PDT
